Category: Wood
Wood Based Products
Actual 3D cutting. Usually, a ball nose bit is used with a fractional step-over per pass to achieve an even surface of cut in the Z axis.
As a rule, this is done with a 3-axis machine. The limitation is that Z is only Vertical.
A 5-axis machine (normally seen as a large arm that articulates in five directions. These are normally referred to as robotic arms. Click here for a you-tube search for robotic arms to see some examples. Normally the Z can come from almost any direction including from the bottom up. i.e. A cut under a wooden rose petal to give it even more of a 3d appearance.
Categories
Orosco Table Restoration
Above are the before pictures of the table needing to be restored. All we need are some new curved benches to match.
Below is the finished restoration.
Infrastructure below the surface boards were replaced to make a more stable top surface. The tabletop was then surfaced with the CNC 1-1/2″ planer bit to flatten the surface. An ogee bit was used to give the edge a more decorative look back to the original look.
Benches were created from new wood and cut on the CNC Router. The new legs for the benches were bolted together for sturdiness. Also notice the spinner caps on the wheels cut separately and attached to the outside of the wheel. Not to forget, I sanded everything for the Orosco’s to finish with the paint you see in the pictures below.
Bernard Brown asked me to cut this gigantic Domino!
[slickr-flickr search=”sets” set=”72157694579155770″ items=”60″ type=”slideshow”]