Categories
3D CNC Material Melamine Router

Topper For My Dining Area

The pictures below are the Topper I made for my dining room. The inserts (there are six per set) are magnetically held in. It was designed to change out for the season or event. Notice the backside hole to put a finger through to pop the section loose from the magnet for a change-out. We are starting out with four sets and see where it goes.

The center Hummingbird is also a change-out. I have our initials to sub out for the Hummingbird.

  • WUD-CNC-2018-0114 Dng Room Window Topper (1)
  • WUD-CNC-2018-0114 Dng Room Window Topper (10)
  • WUD-CNC-2018-0114 Dng Room Window Topper (11)
  • WUD-CNC-2018-0114 Dng Room Window Topper (12)
  • WUD-CNC-2018-0114 Dng Room Window Topper (13)
  • WUD-CNC-2018-0114 Dng Room Window Topper (2)
  • WUD-CNC-2018-0114 Dng Room Window Topper (3)
  • WUD-CNC-2018-0114 Dng Room Window Topper (4)
  • WUD-CNC-2018-0114 Dng Room Window Topper (5)
  • WUD-CNC-2018-0114 Dng Room Window Topper (6)
  • WUD-CNC-2018-0114 Dng Room Window Topper (7)
  • WUD-CNC-2018-0114 Dng Room Window Topper (8)
  • WUD-CNC-2018-0114 Dng Room Window Topper (9)

As of these pictures, there is no finish on it yet. Stay tuned for pictures of the oak rod to be stained with a dark finish.

Leave a Reply